Bendix-commercial-vehicle-systems SMARTIRE TPMS OPERATORS MANUAL Bedienungsanleitung PDF herunterladen (Seite 16)

3.0 CONFIGURING & CUSTOMIZING YOUR SMARTIRE

™

SYSTEM

During the installation process, the default settings for SmarTire

™

TPMS should be customized to

the vehicle by the installer. At any time, alert thresholds can be made more or less sensitive and

system settings can be adjusted to accommodate vehicle changes and use.

Replacing vehicle tires or installing the system on a new vehicle may also require adjustment of

pre-configured settings. The following section describes how to adjust the pre-configured settings

of your SmarTire

™

TPMS.

3.1 PRE-CONFIGURED SETTINGS

Generally, the SmarTire

™

TPMS is pre-configured with the default settings listed below.

Depending on your vehicle, your system may have a different initial setup.

 Cold Inflation Pressure (CIP):

o 6-Wheel (4x2 Configuration)

 Steer Axle: 100 PSI (6.89 bar)

 Drive Axle: 100 PSI (6.89 bar)

o 10-Wheel or 6-Wheel with Super Singles

 Steer Axle: 100 PSI (6.89 bar)

 Drive Axle: 100 PSI (6.89 bar)

 First Alert Level (FAL) Pressure Deviation Alert: CIP +/- 15%

 Second Alert Level (SAL) Critical Low Pressure Alert: CIP -20%

 High Temperature Alert: 185°F (85°C)

Default cold inflation pressure settings should always be customized to the vehicle. Check the

vehicle’s owner’s manual, placard or the industry published load inflation table to determine the

recommended cold inflation pressure settings. Bendix recommends setting the Second Alert

Level (SAL) critical low pressure alert at 20% below the recommended cold inflation pressure for

your vehicle. Bendix also does not recommend changing the First Alert Level (FAL) pressure

deviation alert setting.

3.2 SMARTIRE

™

SENSOR LEARN INSTRUCTIONS

This section contains the instructions to program vehicle sensors into the SmarTire

™

system

using the SmarTire

™

Diagnostic Tool software.

3.2.1 Equipment

Hardware

 On-Vehicle J1939 Diagnostic Port

 J1939 CAN Adaptor (e.g. Vansco DLA, USBLink)

 SmarTire

™

Vehicle Harness

 J1939 Wireless Gateway Receiver

 (Optional) LF Initiator; SmarTire

™

Maintenance Hand Tool; or SmarTire

™

LF Tool

Software

 SmarTire

™

Diagnostic Software (Version 1.0.25 or higher – download at

http://www.smartire.com/support/manuals)

 PC with Microsoft Windows XP

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 79 80

Kommentare zu diesen Handbüchern

Keine Kommentare

Bendix-commercial-vehicle-systems SMARTIRE TPMS OPERATORS MANUAL Bedienungsanleitung Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Bendix-commercial-vehicle-systems SMARTIRE TPMS OPERATORS MANUAL